Complete the table below with your results, and then provide your interpretation at the end.
Note that:
Copyright By PowCoder代写 加微信 powcoder
– When calculating the parallel speed-up S, use the time output by the code, which corresponds
to the parallel calculation and does not include initialising the matrix/vectors or
performing the serial check.
– Take as the serial execution time the time output by the code when run with a single process
(hence the speed-up for 1 process should be 1.0).
No. Process: Mean time (average of 3 runs): Parallel speed-up, S: Efficiency, E(%)
============ ============================== ===================== ================
1 1.0 100%
A brief interpretation of these results (2-3 sentences should be enough):
程序代写 CS代考 加微信: powcoder QQ: 1823890830 Email: powcoder@163.com